The best direct drop-in replacement motor for your Talaria.
Designed from the ground up to give unmatched power and torque. You can now run much higher power levels without the risk of over-heating your motor.
The stock Talaria motor has it's limits and can be prone to overheating when pushing high-powered tunes from aftermarket controllers. If you're a bigger/heavier riders (and/or racer), you've most likely encountered this. KO's Factory Spec motor was built to push higher power but keep temps lower. You'll likely never overheat the KO motor, even when pushing 15KW+ continuous.
Factory spec features a higher KV wind, Magnets imported from Europe and a unique color set with laser etching and ultra high quality finish.
Both the motor and controller are designed to be a plug and play option in the Talaria and are easy to fit, using the same cabling and also the same default Talaria display unit. Gone is the need to upgrade your display unit and run additional extra cabling across your bike.
- Peak 35KW Power (Based upon motor rating, your battery will determine the power you can produce)
- 7075 Aircraft grade billet machined end caps and sensor cap
- Stainless steel waterproof phase and sensor wire glands
- Internal magnet motor (IPM)
- Cold Rolled SAE 1045 Steel rotor Shaft
- Custom KO designed and patented rotor and heat sink design allows heat soak dissipation on the ends of the stator
- Max Torque: @60v -55NM
- Max stable rotor RPM: 12,000
- Max Efficiency: 97%
- Motor Weight: 22lbs
- IP67 ingress protection
- KO patented internals pressure equalization system compatible
- Cryo Cold Air Injection System
- Cryo Rotor/Stator Anti Corrosion Coating
- Industry Leading SKF bearing and seals for lowest rolling resistance and efficiency
- Industry Leading 150°C SH50 Neo Magnets
- Custom Waterproof designed and manufactured hall sensor with 12 month warranty against water/moisture damage.